Print

Reader connection modules


  • Designed to speed up installation
  • Uses the RJ45 plug supplied on the readers
  • Low cost
  • Can be ordered direct from Paxton Access
About - The reader junction box (325-020) and the RJ45 reader port connector (325-030) are designed to make wiring the readers to our control units quick and easy.

During the manufacture of all of our readers, units are checked on automated test equipment to ensure correct operation. An RJ45 plug is fitted to speed up this process and this is left attached to the cable when shipped.

The reader junction box can be used to provide a connection point for the reader RJ45 plug.

The RJ45 reader port connector is designed to convert the standard reader ports on Switch2 and Net2 control units to accept 1 or 2 RJ45 connections.


Installation -
Reader junction box: Plug the RJ45 plug from the reader into the junction box. The terminals on the module are then wired color to color to the controller.

Reader port connector: Pull off the terminal block from the reader port on the control unit and replace it with this connector. Plug in the RJ45 plug from the reader.



Sales code Description